Front Lower Mudguard Assembly (Front Bottom Fender) – Himalayan 450 Hanle Black – RAG00760/B (Genuine OEM)

Royal Enfield RAG00760/B is the front lower mudguard assembly (commonly searched as front bottom mudguard, lower front fender, front fender lower) supplied in Hanle Black specification for the Himalayan 450 (H450) platform. If your lower mudguard is cracked after an off-road fall, scraped by stones, or the mounting tabs/holes have loosened and started vibrating, replacing the correct OEM lower assembly restores factory alignment and a clean stock look.

Because this is a genuine Royal Enfield part, you get the OEM plastic grade, correct hole spacing, and the intended colour/spec finish—important on an adventure bike where fork travel and clearance matter. It’s also searched as Himalayan 450 lower mudguard, H450 front bottom fender, and Hanle Black lower fender.

Before you buy: confirm (1) your bike is Himalayan 450, (2) you need the lower/bottom mudguard piece (not the upper), and (3) you specifically need Hanle Black colour/spec. If unsure, share a photo of your current mudguard area + mounting points before dispatch.

Key Features 

• Genuine OEM Royal Enfield part number RAG00760/B
• OEM parts portals describe it as MUDGUARD, LOWER, ASSY, HANLE BLACK
• Colour/spec: Hanle Black (H450) – factory-correct finish
• Direct replacement for cracked/broken lower mudguard after falls or debris hits
• OEM geometry supports correct tyre clearance and full fork travel
• Helps prevent vibration/rattle from broken tabs or ovalled mounting holes
• Better fit consistency vs generic aftermarket plastics (hole alignment + durability)
• Best for restore-to-stock builds and clean cosmetic refresh

Compatibility Table 

Variants

No variants. This listing is for Hanle Black spec under part number RAG00760/B.

FAQs 

Q1 (Fitment): How do I confirm RAG00760/B fits my Himalayan 450?
Match three things: (1) bike is Himalayan 450 (H450), (2) you need the front lower/bottom mudguard (not the upper), and (3) colour/spec required is Hanle Black. If unsure, share a photo of the mudguard area + mounting points before dispatch.

Q2 (Fitment): Will this work on Himalayan 450 in other colours?
Mounting may be similar, but Royal Enfield commonly assigns different part numbers for different colour/spec finishes. Treat other colours as unverified unless your current part number cross-matches RAG00760/B or you confirm via photo/VIN with a dealer.

Q3 (Comparison): Genuine OEM vs aftermarket lower mudguard—what’s the difference?
OEM pieces typically have more consistent hole alignment, stronger tab plastic, and predictable tyre-clearance geometry. Aftermarket options can work, but misaligned holes or weaker plastic often cause vibration, cracked tabs, and repeat replacements—especially in off-road use.

Q4 (Installation): Any precautions while installing the lower mudguard?
Avoid over-tightening into plastic. Inspect rubber grommets/spacers for wear. Confirm full fork travel clearance after installation and route/seat any clips exactly as stock.

Q5 (Symptoms): What problems does this part solve?
Cracked/broken lower mudguard after a fall, missing tabs, enlarged bolt holes causing rattle, heavy scuffs, and poor fitment from warped/wrong mudguard sections.

Q6 (Returns-prevention): What should I send you to confirm before shipping?
Send (1) a clear photo of the front mudguard area, (2) a close photo of mounting holes/tabs, and (3) your bike’s year/variant/colour. This prevents ordering the wrong upper vs lower section or wrong colour-spec part number.