144766/A Royal Enfield Centre Stand Spring (New) for Classic 500, Bullet 500, GT 535, Himalayan 411 (Euro Spec) | Genuine OEM

If your Royal Enfield main/centre stand is not snapping back firmly, feels “loose,” or rattles over bumps, the spring is usually the first wear item to replace. 144766/A – Centre Stand Spring (New) is a genuine Royal Enfield OEM spring designed to restore correct stand tension and safe retraction, helping prevent the stand from partially dropping while riding.

Unlike many aftermarket springs that vary in wire gauge and tension (leading to early sagging or poor stand return), this OEM part is made to the original spec and is the same type referenced in official dealer microfiche listings. It is commonly searched as main stand spring / center stand spring / centre stand return spring.

Important: centre-stand setups on some Royal Enfield models may use one or two springs depending on variant—so please confirm your required quantity before ordering. If you’re unsure, match by part number 144766 or 144766/A on your existing spring or verify via the Royal Enfield parts lookup for your exact model/VIN.

Key Features

• Genuine Royal Enfield OEM spring: 144766/A

• Restores correct centre/main stand return tension

• Helps reduce stand rattle and improves safe stand retraction

• Durable spring steel construction (OEM spec)

• Direct replacement when part number match is confirmed

• Suitable for models shown in official dealer microfiche assignment list

• Also referenced by dealers as a stand spring used on Himalayan 411 applications

• Ideal preventive replacement during centre-stand service/overhaul

Compatibility Table 

PLEASE CHECK PART NUMBER AND SPARE PHOTO BEFORE PURCHASE

Variants

• Quantity: 1 pc (Single spring – OEM 144766/A)

• Quantity: 2 pcs (Pair) (select this only if your centre-stand setup uses two springs)

FAQs 

1. What is Royal Enfield part number 144766/A?
   144766/A is the Centre Stand Spring (New) used in the centre/main stand return mechanism on specific Royal Enfield models. It is referenced in official dealer microfiche assignment listings as “CENTRE STAND SPRING (NEW).

2. Will this fit my Classic 350 Reborn / Meteor 350 / Hunter 350 / Interceptor 650?
   Not confirmed for those platforms in the sources used for this listing, so do not assume fitment. For J-Series and 650 Twins, verify by searching your exact model/VIN in the Royal Enfield parts catalog or confirm the part number used in your stand assembly before ordering.

3. Do I need 1 spring or 2 springs?
   Some Royal Enfield centre-stand assemblies use two springs, while others use one depending on the model/variant/stand design. Best method: visually check your bike’s centre stand and order the same quantity, or match your old spring’s part number (144766 / 144766/A).

4. My stand is rattling—will changing the spring fix it?
   A weak spring is a common cause of rattling and poor retraction. However, rattles can also come from worn stand bushes, stand stopper rubber, or loose hardware. Replace the spring first if tension is clearly weak; if noise persists, inspect the stand pivots and stopper.

5. Is this spring also used on Himalayan 411 side stand?
   Always confirm your exact fitment by part number before purchase.