Cable Strap 6 Inch (Wiring Harness Cable Tie) for Classic 500 EFI / Electra EFI / Bullet 500 – 141161/C (Replaces 141161)

SOLD AS A SET OF 10 PCS 

FULL PACKET 40 PCS(ADD 40 PCS FOR FULL PACKET)

Royal Enfield Cable Strap 6 Inch (Part No. 141161/C) is the OE-spec wiring harness cable tie used to secure loom sections, battery leads, ECU/relay wiring, and routed cables to the frame without rubbing or sagging. If you’ve opened your harness for repair, added accessories, replaced a main loom, or your old ties have become brittle and snapped, this small part prevents bigger issues—wire chafing, loose routing, intermittent electrical faults, and unwanted vibration wear.

This item is commonly searched as “6 inch cable strap,” “Royal Enfield wiring tie,” “harness zip tie 141161,” “cable strap 141161/C,” and “OEM cable tie Classic 500 Electra EFI.”
This is a single-use locking strap (cut to remove; replace during refit).

Before you buy: confirm you need the 6-inch strap (not 8-inch) and order by part number 141161/C if you’re matching factory spec.

Internal linking suggestions (Shopify SEO): Royal Enfield Wiring Harness & Electrical, Classic 500 EFI Spares, Electra EFI Spares, Bullet 500 Spares.

Key Features

• Genuine-spec Cable Strap 6" for wiring harness routing and retention

• Current part number: 141161/C (supersedes older 141161)

• Helps prevent wire rubbing, slack harness runs, and vibration damage

• Ideal for loom replacement, accessory wiring tidy-up, battery/ECU harness refit

• Single-use locking design (cut to remove; replace during assembly)

• “Also searched as”: zip tie, wiring tie, cable tie, harness strap, loom tie

• Fits multiple Royal Enfield EFI-era harness groups where specified in parts catalogues

Compatibility Table

Variants
No variants.

FAQs 

Q1 (Fitment): How do I confirm this is the correct strap for my bike?
Match part number 141161/C from your parts list or old strap pack, and confirm you need the 6-inch length (not 8-inch). If you’re redoing wiring, confirm the harness section calls for 141161 in the catalogue/diagram.

Q2 (Fitment): Is this 6-inch strap used only on Classic 500 / Electra EFI / Bullet 500?
It’s confirmed in those official parts catalogues. For other Royal Enfield models, it may still be used, but you should order by part number + length requirement unless you can confirm in your model’s diagram.

Q3 (Comparison): What’s the difference between 141161 and 141161/C?
141161 is shown as replaced by 141161/C in dealer part-number mapping. Always buy the current 141161/C when available.

Q4 (Installation): Any precautions while installing cable straps on a wiring harness?
Do not overtighten—leave enough slack so the loom isn’t crushed. Keep the locking head positioned away from sharp edges and moving parts. Always route along the factory path.

Q5 (Symptoms): What problems does replacing these straps prevent?
Loose harness routing, wires rubbing on the frame, intermittent electrical issues from chafed insulation, and vibration-related wear near the battery/ECU/relay area.

Q6 (Returns-prevention): What should I share to avoid ordering the wrong strap?
Share a photo of your harness area showing the strap location + measure the required strap length (6" vs 8"). If you have a parts list screenshot showing 141161/C, share that—best confirmation.