Keep your Guerrilla 450 driving smooth and silent with the genuine Royal Enfield Chain & Sprocket Kit — Part No. KAA00195/C. This factory kit is catalogued specifically for Guerrilla 450 (Sherpa-450 platform, BS6.2/E5) and arrives pre-matched by Royal Enfield: front sprocket, rear sprocket and OE drive chain supplied to the exact pitch, offset and link count specified for the bike. That means correct alignment, cush-friendly engagement, and accurate gearing without the guesswork of mixing aftermarket parts.

Use this kit when your chain has tight spots, the rear sprocket shows hooked teeth, or you hear driveline clatter under load. Because it’s OE, tolerances on the spline, tooth profile and chain dimensions match the hub and countershaft perfectly, protecting seals and bearings and reducing premature wear. For the quietest, longest-lasting result, install as a complete set and lube the chain at the service intervals in your owner’s manual. (Only confirmed fitment is listed to keep returns at zero.)

Key Features

• Genuine Royal Enfield kit: KAA00195/C — made for Guerrilla 450.

• Pre-matched front sprocket + rear sprocket + OE chain (correct pitch & link count for Sherpa-450).

• Factory gearing and alignment → smooth acceleration, reduced noise & vibration.

• Direct fit on stock hub/countershaft; no spacers or re-machining.

• Supplied in OE packaging for quick, no-guesswork replacement.

• Helps protect cush drive, wheel bearings and output-shaft seals.

Compatibility Table 

Exclusions: Not listed for Himalayan 450 or any J-Series/650 models. Order only for Guerrilla 450 where your VIN fiche shows KAA00195/C.

Variants

• KAA00195/C — Chain & Sprocket Kit (Guerrilla 450) (this product)

• Related OE items (order by VIN if needed): front sprocket nut/lock-washer, rear sprocket bolts, chain master link, chain slider & guide.

FAQs

1) What’s inside KAA00195/C?
The OE chain + front sprocket + rear sprocket matched for Guerrilla 450. Exact tooth counts and chain links follow the VIN fiche for this model.

2) Will this fit Himalayan 450?
Not confirmed. This kit is labeled for Guerrilla 450 only. Use the Himalayan-specific kit shown on its fiche.

3) Do I need to change the whole set?
Yes—Royal Enfield recommends replacing chain and both sprockets together to prevent rapid wear-in and noise.

4) Tubeless/ABS compatibility issues?
None. The kit is platform-specific and works with the OE ABS ring and rear hub used on the Guerrilla 450.

5) Any torque or setup tips?
Install with fresh sprocket fasteners if required, set chain slack to the spec in the owner’s manual, and re-torque after the first short ride.

Fits Guerrilla 450 only. Match KAA00195/C to your VIN fiche/box label before ordering; tooth count & link length are model-specific.