Pack Of 5 Pcs
Restore the crisp “flip-up” action of your rider pegs with the genuine Royal Enfield Rider Footrest Spring (Part No. 148559/E). This small but critical spring returns the folding rider footrest to its home position after cornering or tip-overs, preventing the peg from hanging low and snagging on the road. Because it’s OEM, the coil rate, leg angle and wire gauge match the factory peg brackets—no bending or re-profiling needed, and no squeaks or premature sag like cheap copies.

Fitment is verified on the 650 Twins platforms where the model fiches explicitly list “SPRING, RIDER FOOTREST — Product code 148559” with Normal Qty: 2 per bike. The current supply suffix is /E, and older stock 148559/B is shown as superseded on the official parts price page. This contains a set of 5 Pcs Each 

Key Features

• OEM part: 148559/E – SPRING, RIDER FOOTREST

• Verified on 650 Twins fiches with Normal Qty: 2 (one per rider peg). 

• Correct coil rate/leg geometry → smooth folding action & secure return.

• Prevents pegs dragging or staying folded after a strike.

• Direct fit with OE peg bracket, no bending or trimming required.

• Low-cost preventative replacement during peg/bracket service.
  

Compatibility Table 

We list only models where the fiche specifically shows Product code 148559 for the rider footrest spring. Other bikes may use different springs—don’t assume.

Variants

• 148559/E – Rider Footrest Spring (this listing)
  

FAQs

Q1. How many springs does my bike need?
Two—one per rider peg. Full Packet Of 5 Pcs (Is sent )
Q2. Does this fit pillion pegs?
No—this part is specified for rider footrests on the models listed above.

Q3. My spring looks similar—can I mix/match?
Avoid mixing. Geometry varies by bracket. Match the part number in your VIN fiche.

Q4. What else should I inspect?
Check the pivot pin/clevis & circlip for wear and replace if sloppy (see your model’s Foot Controls fiche).