Genuine Rider Seat Assembly for Royal Enfield Meteor 350 | 1100609/G | OEM Seat Assy

If your Royal Enfield Meteor 350 rider seat is torn, sagging, uncomfortable, or its base has cracked, 1100609/G (SEAT ASSY–RIDER SEAT) is the correct genuine OEM rider seat assembly to restore factory fit, comfort, and locking alignment. This is a direct replacement for the front/main rider seat—ideal for bikes used daily, long commutes, or touring where poor seat support increases fatigue and back pressure.

Unlike low-cost aftermarket covers/foam that often mismatch stitching, density, or mounting points, an OEM seat assembly is designed to match the Meteor’s chassis tabs, latch position, and riding posture as per factory spec. This reduces common issues like seat wobble, uneven seating height, and premature foam collapse.

Confirmed application: Meteor 350 rider seat assembly, sold and referenced by dealers under part number 1100609/G and described as SEAT ASSY–RIDER SEAT. 
Note: Royal Enfield uses suffix revisions (e.g., 1100609/C/E/F/G). If your old label shows a different suffix, match your exact part number or confirm via chassis/VIN before ordering. 

Key Features

• Genuine Royal Enfield part: 1100609/G (Seat Assy – Rider Seat) 

• Direct-fit replacement for Meteor 350 rider/front seat 

• Designed for correct latch alignment and factory riding position (OEM spec) 

• Best option to reduce returns vs. generic “universal seat covers”

• Ideal for replacement after tearing, water damage, foam sinking, or base damage

• Clean OEM finish for stock look and better resale presentation

• Compatible with Meteor’s split-seat configuration (rider + pillion are separate parts) 

• Safer purchase for long rides vs. inconsistent aftermarket foam density

Compatibility Table 

Explicit Exclusions (not confirmed for this part number): Classic 350/500, Bullet (UCE/J), Electra, Hunter 350, Himalayan/Scram, Interceptor/GT 650, Super Meteor 650, etc.

Variants

• No variants for this listing (this page is strictly for 1100609/G).

• Other suffix revisions exist (e.g., 1100609/C/E/F)—do not substitute without confirmation. 

FAQs 

1. Is this the front (rider) seat or the pillion seat?
   This is the rider/front seat assembly for Meteor 350. Pillion seat is a different part number. Will 1100609/G fit all Meteor 350 variants (Fireball/Stellar/Supernova)?
   Dealer fitment confirms Meteor 350 coverage; trims typically share the same mounting. Still, if your existing seat label shows a different suffix, confirm by old part number or VIN before ordering. 

2. I have 1100609/F or 1100609/E on my old seat—can I order /G?
   Suffix letters can indicate revisions. Do not assume interchangeability—match your exact suffix or verify by chassis/VIN to avoid returns. 

3. Is it OEM or aftermarket?
   This part is listed as a genuine Royal Enfield spare and described as SEAT ASSY–RIDER SEAT. 

4. Do I need any extra hardware for installation?
   Usually it’s a direct swap. Reuse your existing fasteners/rubber buffers if serviceable; replace worn seat rubbers if the seat rocks.