Royal Enfield 594562 / 594562A Dust Seal – Rear Sprocket Carrier – Classic 350 Reborn, Goan Classic 350 & Meteor 350 (J-Series) – Genuine OEM

The Royal Enfield 594562 / 594562A Dust Seal – Rear Sprocket (DUST SEAL-RD SPROCKET) is the genuine OEM seal used in the rear sprocket carrier (cush drive hub) on J-Series 350 models – specifically Classic 350 Reborn / Goan Classic 350 and Meteor 350.

J-platform rear wheel parts lists for Meteor 350 clearly show 594562/A – DUST SEAL-RD SPROCKET in the rear wheel diagram, confirming it as the sprocket carrier seal for the J-series hub. Multiple international sellers list 594562/A as a genuine rear sprocket dust seal for Classic 350 / 500 and Meteor 350, with dedicated listings for “All New Classic 350 Dust Seal-RD Sprocket 594562”.

This seal sits between the sprocket carrier and the rear wheel bearings, keeping out dust, water and chain lube so your hub and bearings last longer and run smoother. A worn or hardened seal can allow grit into the cush drive, causing bearing noise, wheel play and premature sprocket carrier wear.

Replacing it with a fresh, factory-original 594562/594562A whenever you change the chain–sprocket kit or rear wheel bearings is cheap insurance for your J-Series 350.

Under The Hood supplies only genuine Royal Enfield–branded stock backed by official price lists where 594562/A is listed as NT51 DUST SEAL RD SPRACKET, not local pattern rubber.

Key Features

• Genuine Royal Enfield part – 594562 / 594562A – DUST SEAL-RD SPROCKET (NT51).

• Confirmed in Meteor 350 J-series rear wheel parts list as the sprocket carrier dust seal.

• Widely sold by OE parts dealers as rear sprocket dust seal for All New Classic 350 & Meteor 350.

• Designed for the J-platform rear cush drive hub, sealing the carrier bearings from dust, mud and water.

• Correct OEM dimensions and lip design ensure perfect press-fit and long seal life.

• Ideal replacement whenever you change rear wheel bearings or the chain & sprocket kit on J-Series 350s.

• Helps reduce rear hub play, bearing noise and premature wear caused by a damaged or hardened old seal.

• Supplied as single piece (1 seal) – typically one required per rear wheel on these models.

Compatibility Table – J-Series Focus 

This listing is dedicated to J-Series 350. Your UCE 500/Thunderbird/GT 535 customers should be handled on a separate 594562 page.

✅ Confirmed / Strongly Backed for J-Series

• PLEASE CHECK PART NUMBER BEFORE PURHCASE 

Variants

For J-Series, treat these as same functional part:

• 594562 – base part number used by some dealers.

• 594562/A – updated suffix in newer price lists and Meteor 350 rear wheel parts book.

On-site wording suggestion:

“Current stock may carry either 594562 or 594562/A on the label – both are the same genuine rear sprocket dust seal for J-Series 350.”

What’s in the Box

• 1 × Genuine Royal Enfield Dust Seal – Rear Sprocket (594562 / 594562A)

Installation Notes (J-Platform)

• Located on the sprocket carrier side of the rear wheel; remove the wheel and carrier to access.

• Clean the hub bore, apply a light smear of grease, and press the seal in square using a suitable driver or large socket.

• Lip should face the bearing/grease side (check Meteor/Classic service manual diagram).

• Replace at the same time as rear wheel bearings or chain–sprocket kit for best results.

FAQs

Q1. Will this dust seal fit my J-Series Classic 350 Reborn?
Yes. Several genuine parts sellers list 594562/594562A as “Dust Seal-RD Sprocket 594562 for All New Classic 350”, and the J-Series rear hub design is shared with the Meteor 350, whose parts book explicitly uses 594562/A.

Q2. Is this the correct rear sprocket dust seal for Meteor 350?
Yes. A Meteor 350 rear wheel parts breakdown shows 594562/A – DUST SEAL-RD SPROCKET in the sprocket carrier assembly, confirming this is the correct OEM seal for Meteor.

Q3. Does it fit Hunter 350 and new Bullet 350 (J-Series)?
YES BUT CONFIRM PART NUMBER WITH US!

Q4. Is this part suitable for older Classic 500 / Thunderbird 500 / GT 535?
594562/594562A is also used on many UCE 500 and Thunderbird models, BUT CONFIRM PART NUMBER WITH US!

Q5. Is this genuine Royal Enfield or aftermarket?
This listing is for genuine OEM stock only. Official RE price lists describe 594562/A as “NT51 DUST SEAL RD SPRACKET”, and international OE dealers sell it as a genuine rear sprocket dust seal for Classic 350/Meteor 350.