This is sold as a set of 10 PCS that is full packet.

Genuine Royal Enfield Double Cable Clip (Part No. 1010133/B). This OEM clip secures the front brake hose and ABS sensor wire neatly along the fork/guard or handlebar runs—preventing chafing, snags and steering interference. It’s a small, critical piece that commonly breaks during brake service or off-road use. Because it’s a factory part, it matches the original fit and finish and maintains proper hose routing for safety and longevity.
Compared with generic clips, this exact replacement is sized for Royal Enfield loom/hose diameters and snaps into the OE brackets without trimming or cable ties. Ideal to keep as spares; many models use multiple clips. Material is durable molded plastic designed for outdoor, high-vibration environments.
Fitment is verified against official RE parts microfiche and trusted dealer catalogs. Only confirmed models are listed below—no guesswork. If your bike isn’t listed, please check your ABS/Brake System fiche or message us for a VIN check. 

Key Features:

• OEM Royal Enfield part 1010133/B (supersedes older 1010133/A on many models). 

• Designed to hold front brake hose + ABS sensor cable together for correct routing. 

• Direct snap-fit to OE mounts; no modification required.

• Prevents hose rub, kinks and steering interference; improves service neatness.

• Durable molded plastic suitable for high-vibration, outdoor use.

• Cost-effective—carry spares; several clips are used per motorcycle (qty varies by model/fiche). 

• Verified with official microfiche + multiple dealer sources for accuracy. 

Compatibility Table:

(Models listed only where 1010133/1010133/B is shown on the ABS/Brake System fiche)

Note: Quantity used and exact clip positions vary by model (visible on each model’s ABS/Brake System fiche). Examples show 2–10 per bike. 

Variants: (SOLD AS SET OF 10 PCS)

• Single clip (standard) – no LH/RH.

• Supersession: older 1010133/A replaced by 1010133/B on many models; order by 1010133/B where listed. 

FAQs:

Q1: How many clips does my bike need?
A: It varies by model/ABS layout (typically 2–10). Check your model’s ABS/Brake System fiche for “Normal Qty Required”. 

Q2: Where does this clip fit?
A: It ties the front brake hose to the ABS sensor wire, usually along the fork leg, mudguard stay, or near the upper yoke—exact positions per fiche. 

Q3: Is this genuine OEM?
A: Yes—Royal Enfield 1010133/B, as shown on the official parts catalog. 

Q4: Will it fit non-ABS or drum-brake models?
A: No. This part is listed on ABS/Brake System fiches only; non-ABS or drum models aren’t covered. 

Q5: Does it include screws or brackets?
A: No—this listing is for the clip only. Reuse your OE mounts/hardware.