Front Upper Mudguard (Front Fender Upper) – Himalayan 450 Hanle Black – RAG00382/G (Genuine OEM)

Royal Enfield RAG00382/G is the front upper mudguard (also called front fender upper / upper front mudguard) supplied in Hanle Black specification for the Himalayan 450 (H450) platform. If your current upper mudguard is cracked after an off-road tip-over, scraped from a fall, or the mounting points have become loose and started rattling, replacing the correct upper section restores the factory fit, finish and clearance.

This is a genuine Royal Enfield part, meaning it matches the OEM plastic grade, mounting hole alignment and surface finish intended for the bike. It is frequently searched as Himalayan 450 front mudguard, H450 front fender, upper mudguard black, and in workshops simply as front mudguard top.

Before you buy: confirm (1) your bike is Himalayan 450, (2) you specifically need the upper mudguard piece (not the lower), and (3) you want the Hanle Black colour/spec. If unsure, share a clear photo of your existing mudguard + mounting points before dispatch.

Key Features

• Genuine OEM Royal Enfield part number RAG00382/G
• Part description commonly listed as MUDGUARD, FRONT, UPPER, BLACK
• Hanle Black spec (colour/finish matched to the Hanle Black variant family)
• Direct replacement for damaged/cracked upper mudguard section
• Factory-correct mounting alignment and panel gap consistency
• Helps prevent mudguard vibration/rattle caused by broken tabs or ovalled holes
• OEM surface finish and durability vs generic aftermarket plastics
• Suitable for restore-to-stock builds and clean cosmetic refresh

Compatibility Table 

Variants

No variants. (This listing is for Hanle Black spec under part number RAG00382/G.)

FAQs

Q1 (Fitment): How do I confirm RAG00382/G fits my Himalayan 450?
Match three things: (1) your bike is Himalayan 450 (H450), (2) you need the front upper mudguard section (not the lower), and (3) your existing part/colour spec corresponds to Hanle Black. If unsure, share a photo of the mudguard + mounting points before dispatch.

Q2 (Fitment): Will this work on Himalayan 450 in other colours?
The mounting may be the same, but Royal Enfield commonly uses different part numbers for different paint/colour specs. Treat other colours as unverified unless your current mudguard’s part number cross-matches RAG00382/G or you confirm via photo/VIN with a dealer.

Q3 (Comparison): Genuine OEM vs aftermarket mudguard—what’s the real difference?
OEM pieces typically have more consistent hole alignment, stronger tab plastic, and a closer surface finish match. Aftermarket options can work, but misaligned holes or weaker plastic often cause vibration, cracked tabs, and repeat replacements—especially on adventure use.

Q4 (Installation): Any precautions while installing the upper mudguard?
Work on a clean surface. Avoid over-tightening fasteners into plastic, and inspect rubber grommets/spacers for wear. Route any brake line guides exactly as stock and confirm full fork travel clearance before riding.

Q5 (Symptoms): What problems does this part solve?
Cracked/broken upper mudguard after a fall, missing tabs, enlarged bolt holes causing rattle, ugly scratches/scuffs, and poor fitment from a previously installed wrong piece.

Q6 (Returns-prevention): What should I share with you to confirm before shipping?
Send (1) a clear front-side photo of the mudguard area, (2) a close photo of the mounting holes/tabs, and (3) your bike’s year/variant/colour. This prevents ordering the wrong “upper vs lower” section or the wrong colour-spec part number.