Genuine Tail Lamp Assembly (Rear Tail Light) for Royal Enfield Shotgun 650 (2024→) – RAN00398/B

Restore factory-correct rear visibility with the Royal Enfield Genuine Tail Lamp Assembly – RAN00398/B, the complete rear tail light unit used on the Shotgun 650 (2024-on). If your lens is cracked, housing is broken, water has entered the unit, or the tail/brake light has become intermittent, replacing the full assembly is the safest, most reliable fix—especially on premium 650 platforms where clean fitment and connector sealing matters.

This is the complete tail lamp assembly (not just a lens), designed to mount in the stock location and connect to the OE harness without improvised wiring when matched correctly. It is also commonly searched as tail light assembly, rear tail lamp, brake light unit, back light, taillight, and tail lamp assy.

Before you buy: Confirm your bike is a Shotgun 650 (2024+) and match the part number RAN00398/B and connector style with your existing unit/photo to avoid wrong orders.

Key Features 

• Genuine Royal Enfield replacement part: RAN00398/B

• Complete tail lamp assembly (rear tail/brake light unit), not a lens-only piece

• Verified listed for 650 Shotgun (2024–on) in partsbook references

• Correct mounting geometry for OE rear fitment (when matched to the same model/platform)

• Helps resolve: cracked lamp, broken housing, moisture ingress, flicker/intermittent tail light (wiring/connector must be checked)

• Ideal for accident repair, restoration to stock look, and export-ready compliance-focused replacement

• Return-prevention friendly: buy by part number + model/year first

Compatibility Table

Variants

No variants. (Order exactly RAN00398/B.)

FAQs 

Q1 (Fitment): How do I confirm this tail lamp fits my bike?
Check your RC/service records for Shotgun 650 (2024+), then match part number RAN00398/B and compare a photo of your existing tail lamp + connector to prevent mismatch.

Q2 (Fitment): Will it fit Interceptor 650 / Continental GT 650 / Super Meteor 650?
Not confirmed. Only Shotgun 650 (2024–on) is validated in a model-specific partsbook reference. For other 650s, treat as unverified unless you confirm via EPC/VIN or a dealer microfiche listing for your exact model.

Q3 (Comparison): Why choose OEM/Genuine over aftermarket tail lamps?
Genuine units are built to OE tolerances for mounting alignment, connector fit, and sealing. Aftermarket lamps often cause gaps, water entry, loose connectors, or inconsistent brightness—leading to repeat failures and returns. (Buyers also avoid “looks same but doesn’t fit” errors.)

Q4 (Installation): Is installation plug-and-play? Any precautions?
Typically straightforward: remove rear cover/fasteners, disconnect the harness, swap the unit. Precautions: inspect for pin corrosion, don’t pinch the harness, and ensure the grommet/seal sits correctly to prevent moisture ingress.

Q5 (Symptoms): What issues does replacing the complete tail lamp solve?
Cracked lens/housing, broken mounting tabs, water inside lamp, and persistent tail/brake light intermittency (if the fault is within the lamp unit). If the issue remains, diagnose wiring/ground and the rear harness connector.

Q6 (Returns-prevention): What photo should I share before ordering to avoid a wrong part?
Send (1) your bike model/year (Shotgun 650), (2) a clear photo of the installed tail lamp from rear/side, and (3) a close-up of the connector/pins and mounting points. This prevents cross-model mistakes.