Speedometer Rubber Ring for Royal Enfield Bullet 500 & Classic 500 (Instrument Seal) | 110179 | Genuine OEM

The Royal Enfield 110179 Speedo Meter Rubber Ring is the OEM rubber sealing ring that sits around the speedometer to help it seat correctly and reduce vibration-related movement, rattles, and dust/water ingress at the instrument mounting area. If your speedometer feels slightly loose, you hear minor rattling from the console/nacelle, or you’re rebuilding the headlight/instrument area after paintwork or repair, replacing this small rubber ring is a low-cost fix that helps restore the factory fit and finish.

This is a genuine OE part (110179) and is listed in dealer microfiche part assignment against multiple Bullet/Classic 500 variants (Euro 3/Euro 4 and special editions). 
It is also sold by Hitchcocks as “RUBBER RING, SPEEDOMETER” under the same part number, reinforcing correct part identification. 

Because meter housings and console designs can vary across platforms and years, the safest ordering method is to match part number 110179 (or confirm via your VIN/microfiche) before purchase.

Key Features 

• Genuine Royal Enfield part number 110179 

• OEM description: SPEEDO METER RUBBER RING 

• Helps speedometer sit properly in the housing/console

• Reduces minor vibration rattle and movement at the meter area

• Helps improve sealing against dust and splash at the speedometer seat

• Ideal for restorations, repaint jobs, and headlight/console rebuilds

• Better long-term fit than generic rubber rings of incorrect thickness

• Small “must-have” item for workshops and DIY rebuild kits

Compatibility Table 

PLEASE CHECK PART NUMBER BEFORE PURCHASE 

❓Not confirmed (excluded to reduce returns)

Classic 350 (UCE), Bullet 350 (UCE), Electra 350 (UCE), J-Series bikes, 650 Twins, Himalayan/Scram — these may appear on some retailer fitment lists, but they are not confirmed in the microfiche assignment evidence used above.

Variants

• Single unit (110179)

• No LH/RH, no color variants

FAQs 

1) What is 110179 used for?
It is the speedometer rubber ring (meter seating/sealing ring) used at the speedometer mounting. 

2) My speedometer is rattling—will this fix it?
If the rattle is due to a worn/missing rubber ring or loose seating, yes. Also check meter clamp/fasteners and the console mounting.

3) Does it fit my Classic/Bullet 350?
Not confirmed here, so it’s excluded. If your old part is stamped/packed as 110179, then it’s the right match.

4) Is installation DIY?
Yes for most users—remove the meter/console carefully, swap the rubber ring, and refit without pinching the rubber.