Stop Plate, Foot Control for Royal Enfield Bullet 350/500, Electra 4S, Lightning 535 (4-Speed Retired Models) | 111120/2 | Genuine OEM

Royal Enfield 111120/2 is the genuine Stop Plate – Foot Control, used in the 4-speed gearbox end-cover / foot-control ratchet mechanism on Royal Enfield Retired Models. This stop plate controls/limits movement within the foot-control selector mechanism so the ratchet and related parts operate with correct travel and alignment. When this plate is bent, worn, or incorrectly fitted, riders commonly face inconsistent shifting, increased play, or a “notchy” feel—especially during frequent city gear changes.

This is an OEM (Genuine Royal Enfield) part, meaning correct thickness, hole spacing, and fitment versus generic aftermarket plates that often look similar but cause alignment issues and repeat wear. The official Retired Models parts catalogue lists 111120/2 as “Stop plate, Foot control” in the Gear Box End Cover – 4 Speed section, and independent dealer catalogues also list it as the genuine stop plate. 

Best practice: replace the stop plate when overhauling the foot control/ratchet mechanism, and always check the washer (150209) and fasteners for correct stack-up to reduce repeat failure.

Key Features 

• Genuine Royal Enfield part number 111120/2 (factory-spec replacement) 

• Official name: Stop plate, Foot control 

• Used in Gear Box End Cover – 4 Speed foot-control/ratchet mechanism 

• Helps maintain correct ratchet/selector travel for consistent shifting

• Correct OEM thickness & alignment vs many aftermarket plates

• Ideal during restoration / gearbox end-cover rebuilds on older Bullets

• Quantity: 1 per vehicle (catalogue line), dealers may pack in multi-qty boxes 

• No color/finish variants (functional steel plate)

Compatibility Table 

PLEASE CHECK PART NUMBER BEFORE PURCHASE 

Explicit Exclusions (to reduce returns)

• ❌ UCE 350/500, ❌ J-Series 350, ❌ 650 Twins, ❌ Himalayan/Scram/450
  Reason: official listing places 111120/2 in the retired-model 4-speed gearbox end-cover/foot control group, not modern platforms. 

Variants

• No variants (single SKU): 111120/2

• Cross-reference: base number 111120 is shown as replaced by 111120/2 on dealer catalogues.

FAQs 

1) What does the 111120/2 stop plate do?
It is the Foot Control Stop Plate inside the 4-speed gearbox end-cover mechanism, used to control/limit travel and maintain correct selector/ratchet alignment. 

2) Is 111120/2 the same as 111120?
Most catalogues show 111120 as replaced by 111120/2. If your old reference says 111120, order 111120/2.

3) Will this fit Classic 350 Reborn / Meteor / Hunter?
No. Those are J-Series models with a different transmission architecture. This part is for retired 4-speed applications. 

4) What symptoms suggest this plate is worn/bent?
Hard/erratic shifting, excess play in foot-control mechanism, inconsistent engagement after a gearbox end-cover service.

5) What should I check during installation?
Confirm correct washer stack (e.g., 150209 washer) and fastener torque, and inspect related ratchet parts during overhaul.