1 1

UNDER THE HOOD

Tail Lamp / Number Plate Shroud Beading for Royal Enfield Classic 350 Reborn (J-Series) | 1100071/D | Genuine OEM

Tail Lamp / Number Plate Shroud Beading for Royal Enfield Classic 350 Reborn (J-Series) | 1100071/D | Genuine OEM

Rs. 70.00
Rs. 70.00
Sale Sold out
Shipping calculated at checkout.
Important Order Policy
Please order only after confirming the part number, model, variant, year, side, connector type and compatibility. All orders are non-cancellable once placed. Correctly shipped spare parts are not eligible for return, exchange or refund due to wrong selection, wrong diagnosis, fitment mismatch, mechanic recommendation or change of mind. Electrical/electronic items are additionally non-returnable once opened, installed, plugged in, tested or used. Wrong item, damaged item or missing item claims require a complete unboxing video within 24 hours. Read full Return & Warranty Policy

Replace cracked, missing, or hardened rear trim with the Genuine Royal Enfield BEADING – SHROUD J1A (Part No. 1100071/D)—a small but important finishing part that helps keep your rear section looking factory-fresh. Royal Enfield lists this part as “BEADING – SHROUD J1A”. 

This beading is commonly referred to as tail lamp shroud beading / rear number plate beading, and it is used around the rear shroud/edge area to improve fit-and-finish, reduce rattles, and protect edges from dust, water splash, and vibration-related wear. When the original trim gets brittle, you often see rough panel edges, extra vibration noise, and an “unfinished” look.

Choose OEM over cheap aftermarket rubber because OEM beading typically matches the correct profile, density, and locking lip, giving cleaner alignment and longer life.

Fitment note (important): Market listings commonly map 1100071/D to Classic 350 Reborn / J-Series (2021+)—please match your old part number or confirm by VIN/microfiche before ordering to avoid wrong fitment. 

Key Features 

  • Genuine Royal Enfield trim part (OEM)

  • Part Number: 1100071/D

  • Official naming: BEADING – SHROUD J1A 

  • Helps improve rear section finish (clean edging + factory look)

  • Can reduce minor rattles/vibration caused by worn/loose trim

  • Protects shroud edges from dust, splash, and abrasion

  • Quick replacement; ideal during tail tidy / rear panel service

  • Better profile fit vs many generic aftermarket beadings

Compatibility Table

Model Engine Type / Platform BS Stage Years
Royal Enfield Classic 350 Reborn / New Classic 350 J-Series 349cc BS6 2021–Present 

❓ Not confirmed: Meteor 350 / Hunter 350 / Himalayan / Scram / 650 Twins — do not order for these unless your VIN microfiche shows 1100071/D.

Variants

  • Single: 1100071/D (Beading – Shroud J1A)

FAQs 

Q1. What is 1100071/D used for?
It’s BEADING – SHROUD J1A, commonly sold as tail lamp shroud / rear number plate beading for the rear section finishing. 

Q2. Will it fit Meteor 350 / Hunter 350?
Not confirmed. Order only if your bike’s parts catalog/VIN microfiche shows 1100071/D.

Q3. Is this OEM or aftermarket?
This is listed as a Royal Enfield genuine/OEM part number. 

Q4. How do I avoid ordering the wrong beading?
Match the part number on your old beading/packing or confirm via VIN/microfiche before purchase.

Verify Fitment on Official Brand Portals

For selected genuine spare parts, you can cross-check the part number on the official brand portals before ordering.

Royal Enfield Official Spares Portal

Hero MotoCorp Official eCatalogue

View full details